Show more

CadQuery community member Adam will be giving a talk on creating assemblies in CadQuery tomorrow (Sunday). fosdem.org/2021/schedule/event

Kinda a content creator now?? Video scheduled to go public tomorrow at 12pm PT/3pm ET

And we're back up. I added some storage and the integrity checks always take awhile.

Show thread

I'm going to be doing some server maintenance on the Makerdon instance. There may be some service interruptions.

Made a 3D-printed door handle for the front screen door. It has a printed M12 thread inside and there’s a bolt going through from the outside of the door — easy as. #tinkering

Getting Started with Raspberry Pi Pico - Raspberry Pi Foundation - The Pico is a new microcontroller.

raspberrypi.org/documentation/

BeagleV - Looks like BeagleBoard.org and Seeed Studio are planning to launch an open hardware RISC-V development board capable of running Linux for about $150 USD. beaglev.seeed.cc/

The milling side is finally done after about ten hours on the CNC! I still plan to chamfer and reduce the diameter in the lathe, then drill & thread a hole in the back for threaded rod for the handle. #tinkering

Show thread

ESP8266 Socket is a Snap-Fit, Breadboard-Friendly Wonder

It all started with wanting to program an ESP-12 variant of an ESP8266 module without involving any solder. Displeased with all the socket offerings on Thingiverse, [tweeto] set out to design thei… hackaday.com/2021/01/10/esp826

Original tweet : twitter.com/hackaday/status/13

Turning a Waffle Iron into a Reflow Station

There are a ton of ways to go about building your own reflow oven. Most of these builds start with, well, an oven — usually a toaster oven — with a small but significant minority choosing to modify a hotplate.… hackaday.com/2021/01/10/turnin

Original tweet : twitter.com/hackaday/status/13

Show more
Makerdon

The social network of the future: No ads, no corporate surveillance, ethical design, and decentralization! Own your data with Mastodon!